3 DAY PRACTICAL TESTING WORKSHOP: LONDON, KINGSTON.
The course spans THREE consecutive days.
It is a requirement of attending this workshop that delegates have gained their City & Guilds 2382 certificate.
This workshop has been developed to bridge the gap between those candidates who have little or no practical testing experience who need to gain practical instruction in testing in preperation for either Part P registration, City & Guilds 2392-10 Level 2 Certification or City & Guilds 2392-20 Level 3 Certification Courses.
Please note that the above courses have practical testing as part of the course assessment. But candidates are not instructed on how to test as part of these courses and will need this knowledge for the assessments.
It addresses the theoretical side of each test followed by practical training.
| COURSE CONTENT
GENERAL REQUIREMENTS - Theory of each test
- Use of forms
- Completing of forms
- Analysis of results
INITIAL VERIFICATION - Certificates
- Required information
- Scope
- Frequency of subsequent inspections
- Initial inspection
- Initial testing
PERIODIC INSPECTION AND TESTING - Necessity for periodic inspection and testing
- Electricity at Work Regulations
- Design
- Required information
- Requirements for inspection and testing
- Routine checks
TEST INSTRUMENTS - Instrument standard
- Instrument accuracy
- Low-resistance ohmmeters
- Insulation resistance ohmmeters
- Applied voltage testers
- Earth fault loop impedance testers
- Earth electrode resistance testers
- RCD testers
FORMS - Initial inspection and testing
- Minor works
- Periodic inspection
|